Technical insight

Vacuum Chamber Flange Flatness After Welding: What to Put on the Order

Specify the flange face to check, the support condition, and whether post-weld facing is permitted. Capture the cooled weldment before committing to a correction, then verify the released geometry and any required leak test separately.

Ribbed housing illustration with raised circular flange and mounting holes
Housing illustration for locating a raised flange face. The drawing for the ordered part determines which face to inspect and whether it is welded.

Define the final face and the part condition

A welding sequence can change the amount and shape of distortion in a fabrication. TWI describes how restraint, assembly technique, and welding sequence affect distortion. Evaluate those choices against the approved weld procedure and drawing.

Identify the exact face or annular land to check on the drawing. A flange can have separate locating, seating, and sealing features. Give each relevant characteristic its own callout. Specify how the inspector should support the cooled assembly and whether the reported face is checked as welded, after permitted facing, or after all final operations.

Put the welding and machining decision in writing

The Shanghai Synchrotron Radiation Facility team reported checking chamber distortion between weld stages and using the measurements to guide the remaining weld sequence. The prototype report documents helium leak checks separately after welding.

If post-weld facing is permitted for the ordered face, review how the fabrication will be located for the finishing cut and how much stock the drawing allows. At the post-weld checkpoint, compare the measured map with the remaining stock and the drawing’s minimum section. A proposed cleanup that would change a seal detail or shift an interface is a disposition question for the design authority.

CheckpointWhat to documentRelease action
Purchase orderSurface IDs, assembly drawing revision, support condition and any prohibited facesHave engineering resolve an ambiguous or missing finishing allowance before welding.
Cooled weldmentFace map with flange IDs, support points and locations referenced to the drawingUse the map to decide whether the approved next operation can achieve the specified face without affecting adjacent features.
Facing authorizedStock remaining, cut boundary and setup datumCheck that seating depth, edge features and mounting interfaces remain within the drawing after the final cut.
Facing prohibitedMeasured as-welded geometry and affected characteristic IDsHold an out-of-limit face for written disposition. Protect the seal geometry from unapproved cleanup.
Final releaseFinal dimensional record, cleaning status and any specified leak test for the same assemblyRelease against each specified check using the assembly identifier on every record.

Separate flatness, orientation, and sealing

Define the flatness check for the face itself. If the face must also align to the chamber opening or a second flange, name the corresponding orientation or location characteristic and its inspection reference. Ask for the data behind any summary pass result on a pilot order so you can see where the face changes around the ring.

For a welded housing with several ports, agree whether a representative first article should be checked at every flange face. Mark the ports on a drawing or a report image so the fabrication team can trace any localized deviation back to the specific interface.

Inspection scope and documentation are defined during quotation according to drawing requirements and application needs.

Frequently asked questions

Should the shop machine every flange face after welding?

Use the permitted route for each individual face. If the drawing or fabrication specification prohibits a cut, send the post-weld result for disposition before any rework.

What if the flange passes flatness but the vessel fails the leak test?

Keep the dimensional and leak-test records linked to the assembly. Investigate the reported leak in the agreed test boundary and follow the approved disposition before releasing the assembly.

Related review paths

More from Blog

References

  1. Distortion Control: Prevention by Fabrication Techniques — TWI. Accessed 2026-11-16T01:48:27.740Z.
  2. The Vacuum Chamber for the SSRF Storage Ring, sections 3.3 and 4 — Yin et al., APAC 2001 proceedings. Accessed 2026-11-16T01:51:42.735Z.

Drawing-led review

Move from general guidance to drawing review

Share the controlled drawing, material, quantity and verification requirements for project-specific review.

Discuss Your Drawing